Tamago Example for Pi Zero

This is an example 'hello world' type application that runs on the Raspberry Pi Zero. The example just flashes the on-board activity LED. Connect a UART cable to see diagnostic output.

Prerequisites

To use this example, you need:

• A FAT-formatted micro-SD card with the Raspberry Pi bootloader present (bootcode.bin, start.elf, fixup.dat)

Build & install example

export TAMAGO=~/work/tamago-go/bin/go
export CROSS_COMPILE=arm-linux-gnueabi-
export INSTALLDIR=/mnt/sdcard
make install

The install target will perform these steps:

1. Compile the example using TAMAGO Go compiler
2. Copy these files to the SD card:
   • config.txt (the Pi config to load the example as a 'kernel')
   • example-pi-zero.bin (the example)