visor instructions - attachment screws unclear #3
Description
At the attach circuit to backpack step the instructions are a little unclear about which spots on the board to attach to the backpack. It says to use four 10mm screws but there are six possible holes that could be used. (There are also six 10mm screws, but I haven't gotten far enough to know if the two other screws are going to be used for something else.)
At the next step, attach ribbon cable red and black/white wires, I assume that you are supposed to attach them between the board and the washer, so that means you have to put two of the 10mm screws from the previous step in those spots. (I had not chosen both of those spots in the previous step, and I had to backtrack.)
The text in that next step is also inconsistent (or I am confused). It says "Take 2 of the 6mm machine screws and 2 of the M3 nuts" but then says "using the 10mm machine screw and one of the M3 nuts" twice. It seems like you should reuse the 10mm screw assemblies from the previous step, so that there wouldn't be anything new in this step? Or maybe you are supposed to finish off the six posts in this step?
Anyway, having fun but the docs could be a little clearer at this point. Thanks!