Closed
Description
@everslick can you close these Issues, they are no longer relevant.
- More than 32 bytes cannot be written via I2C #246 Fixed with RC1
- onReceive in Wire.h? #784 duplicate of I2C Slave not implemented #118
- Erro: I2c serial communcation problem #1093 fixed with RC1
- Wire.Begin(4,0) doesn't seem to work: Can GPIO0 mux with I2C clock(SCL)? #1236 Fixed with RC1, boot strapping pin problem
- ESP32 with Wifi messes up i2c bus reads (MPU6050) #1352 Fixed PR Improve I2C bus recovery of Interrupted READ cycle #1767
- 2 I2C ports #1438 Fixed, user coding error
- DEbug messages when using i2c #1558 Fixed PR Improve I2C bus recovery of Interrupted READ cycle #1767
- Trying to upload voice recognition code, and also helloworld is giving me issues, not sure what to do #1561 this one is just bizarre, it is abandoned and the OP was just acting silly
- i2c speed dropping down #1563 Fixed PR Improve I2C bus recovery of Interrupted READ cycle #1767
- [ESP32] I2C Interrupt problem since uprade to Espressif 1.1.0 #1588 fixed with PR Improve I2C bus recovery of Interrupted READ cycle #1767
- Sensor VEML770 data not change (Wire) #1657 fixed with PR ReSTART fix, with others #1717
- [i2c] MLX90614 #1694 fixed with PR ReSTART fix, with others #1717
- esp32-arduino I2C does not support slave mode? #1697 Duplicate of I2C Slave not implemented #118
- Update IDF to aaf1239 breaks Wire library endTransmission() #1725 request to change Wire.endTransmission(sendStop) parameter to byte, not accepted
- Conflict between accelerometer MPU-9265 and Oled SSD1306 #1778 Problem with user's board/hardware
Chuck.
Metadata
Metadata
Assignees
Labels
No labels
Activity
everslick commentedon Sep 20, 2018
Will do so the next days... Thanks for your work!
copercini commentedon Sep 21, 2018
@stickbreaker I closed all the issues on list, thanks for you work and organization =)
bperrybap commentedon Sep 22, 2018
In #1725 I wasn't asking to change Wire.endTransmission(sendStop) parameter to use a byte parameter.
I was saying that endTransmission(0) and endTransmission(1) should work as it does in every other Arduino core.
bperrybap commentedon Sep 22, 2018
PR created for issue #1725 : #1888