Frame Width and Height not updated when changed in the middle of an ongoing capture session

[bonnyMahajan10]

Observed from ARViewTest App.
If I start a NativeCaptureSession when in Portrait mode on my phone, and switch while the session is ongoing - the variables for capturedFrame.width and capturedFrame.height remain the same as they were at the start of the session (instead of being updated). I imagine if my phone changes orientation (say portrait to landscape or vice versa) - these variable should (roughly not exactly) switch.

[andrewmo2014]

For our use case, we lock device orientation when capturing videos. By not doing so, the following artifacts can be observed when capturing frames and switching orientation (portrait to landscape):

47f5f16c-832f-4195-ba2e-30a85c22be5f.mp4

Are there any safeguards that can be introduced on the Babylon Native side, or is our workaround of locking the device orientation while capturing videos sufficient?

[bghgary]

Closing since this is a short-term solution and thus a short-term issue.